15S10 1.0710 - DIN 1651-1988

Grade	15S10
Germany W-Nr.	1.0710
Corresponding Standard	DIN 1651-1988 Free-cutting steels technical delivery conditions
Classification	Carbon Steel
Properties	Machinability Carburizing Ability

15S10 Chemical Element Composition Content (%)

Component	C	Si	Mn	P	S
Minimum Value	0.12	0.1	0.7	-	0.08
Maximum Value	0.18	0.3	1.1	0.06	0.13

①Elements not listed in the table (except for finishing the cast) shall not be intentionally add to the steel. Such introduction may only be agreed upon with the customer if it can be demonstrated to improve machinability.

15S10 Mechanical Properties

condition	Heat Treatment or Condition	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %	Hardness HBW
Bar, semi-finished product, wire; t ≤ 10	Hot Work (U) or Hot Work and Peeling (U+SH)	420~600			≤176
Bar, semi-finished products, wire rod; 10 < t ≤ 16	Hot Work (U) or Hot Work and Peeling (U+SH)	410~600			≤159
Bar, semi-finished products, wire rod; 16 < t ≤ 40	Hot Work (U) or Hot Work and Peeling (U+SH)	400~560			≤166
Bar, semi-finished products, wire rod; 40 < t ≤ 63	Hot Work (U) or Hot Work and Peeling (U+SH)	380~550			≤162
Bar, semi-finished products, wire rod; 63 < t ≤ 100	Hot Work (U) or Hot Work and Peeling (U+SH)	380~550			≤162
Bar, semi-finished product, wire; t ≤ 10	Cold Drawing (K)	520~820	≥420	≥6
Bars, semi-finished products, wire rods; 10<d≤16	Cold Drawing (K)	500~780	≥400	≥7
Bars, semi-finished products, wire rods; 16<d≤40	Cold Drawing (K)	450~720	≥360	≥8
Bars, semifinished products, wire; 40<d≤63	Cold Drawing (K)	400~650	≥300	≥9
Bars, semi-finished products, wire rod; 63<d≤100	Cold Drawing (K)	380~620	≥250	≥10
Bar, Semi-finished, Wire; d≤100	Cold Drawn and Stress Relief (K+S)	≤580

①A structure is usually defined first, followed by heat treatment (e.g., K+V). When the sequence is reversed, especially for steels such as 45S20, 45SPb20, and 60SPb20, the values to be complied with must be agreed upon.
②The minimum transverse elongation in a tensile test applies to steels 9Mn28, 9SMnPb28, 15S10, 10S20, and 10SPb20 in structural or heat-treated states U+SH and K+S.
③Round bars exceeding 50mm in diameter are generally supplied in a peeled condition rather than cold-drawn.

Approximate Comparison Table Free-Cutting Structural Steel

Germany	European Standard
DIN EN/DIN	EN	Numerical Grade
15S10	15S10	1.0710

15S10 Corresponding Standards(Same grade name, different standards)

1	EN 10305-1-2010
	15S10 1.0710
2	DIN 1651-1988
	15S10 1.0710

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!