CuAl10Fe1 CW305G - DIN EN 12163-2016

Grade	CuAl10Fe1
Germany W-Nr.	CW305G
Corresponding Standard	DIN EN 12163-2016 Copper and copper alloys – Rod for general purposes
Classification	Copper and Copper Alloys
Density	7.6 g/cm³

CuAl10Fe1 Chemical Element Composition Content (%)

Component	Fe	Si	Mn	Ni	Pb	Al	Zn	Sn	Other Total	More
Minimum Value	0.5	-	-	-	-	9	-	-	-	Cu:余量
Maximum Value	1.5	0.2	0.5	1	0.02	10	0.5	0.1	0.2	Cu:余量

"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.

CuAl10Fe1 Mechanical Properties

diameter/width arcoss-flats d/t mm	Mark	Heat Treatment or Condition	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %	Hardness HBW
10<d/t≤80	CuAl10Fe1-R530	R530	≥530	≥290	≥10(A)
10<d/t≤80	CuAl10Fe1-H130	H130				130~170
10<d/t≤30	CuAl10Fe1-R630	R630	≥630	≥490	≥5(A)
10<d/t≤30	CuAl10Fe1-H155	H155				≥155
All specifications	CuAl10Fe1-M	M	No specification	No specification	No specification	No specification

①Material condition names and character codes:
H - Hardness (Brinell or Vickers hardness), with the suffix number indicating the hardness value.
R - Tensile strength, with the suffix number indicating the minimum tensile strength value.
M - Manufactured without specified mechanical properties.
Refer to standard EN 1173-2008.
②A100、A11.3、A-gauge length

CuAl10Fe1 Corresponding Standards(Same grade name, different standards)

1	EN 12163-1998
	CuAl10Fe1 CW305G
2	DIN EN 12163-1998
	CuAl10Fe1 CW305G
3	DIN EN 12163-2016
	CuAl10Fe1 CW305G
4	EN 12163-2016
	CuAl10Fe1 CW305G
5	EN 12167-2024
	CuAl10Fe1 CW305G

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!