Grade CuAl10Ni5Fe4
Germany W-Nr. CW307G
Corresponding Standard DIN EN 12163-2016
Copper and copper alloys – Rod for general purposes
Classification Copper and Copper Alloys
Density 7.6 g/cm3
CuAl10Ni5Fe4 Chemical Element Composition Content (%)
Component Fe Si Mn Ni Pb Al Zn Sn Other Total More
Minimum Value 3 - - 4 - 8.5 - - - Cu:余量
Maximum Value 5 0.2 1 6 0.05 11 0.4 0.1 0.2
"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.
CuAl10Ni5Fe4 Mechanical Properties
diameter/width arcoss-flats
d/t
mm
Mark
Heat Treatment or Condition
Tensile Strength
σb
Mpa
Yield Point
σs
Mpa
Elongation or Extension Rate
δ
%
Hardness
HBW
10<d/t≤120 CuAl10Ni5Fe4-R680 R680 ≥680 ≥320 ≥10(A)
10<d/t≤120 CuAl10Ni5Fe4-H170 H170 170~210
10<d/t≤80 CuAl10Ni5Fe4-R740 R740 ≥740 ≥400 ≥8(A)
10<d/t≤80 CuAl10Ni5Fe4-H200 H200 ≥200
All specifications CuAl10Ni5Fe4-M M No specification No specification No specification No specification
①Material condition names and character codes:
H - Hardness (Brinell or Vickers hardness), with the suffix number indicating the hardness value.
R - Tensile strength, with the suffix number indicating the minimum tensile strength value.
M - Manufactured without specified mechanical properties.
Refer to standard EN 1173-2008.
②A100、A11.3、A-gauge length
New and Old Grade Replacement List
Approximate Comparison Table Cupper and cupper alloy
Japan United States International Organization for Standardization Germany France European Standard Russia United Kingdom
JIS UNS ISO DIN EN/DIN W-Nr. NF EN/NF EN Numerical Grade GOST BS EN/BS
C6301 C63000 CuAl10Ni5Fe4 CuAl10Ni5Fe4 2.0966 CuAl9Ni5Fe3 CuAl10Ni5Fe4 CW307G BrAZHN10-4-4 CA104

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!