C16E 1.1208 - EN 10277-2018

Grade	C16E
European Standard Steel Grade	1.1208
Corresponding Standard	EN 10277-2018 Bright steel products - Technical delivery conditions
Classification	Carbon Steel

C16E Chemical Element Composition Content (%)

Component	C	Si	Mn	P	S	Cr	Ni	Cu	Mo
Minimum Value	0.12	0.15	0.6	-	0.02	-	-	-	-
Maximum Value	0.18	0.4	0.9	0.025	0.04	0.4	0.4	0.3	0.1

C16E Mechanical Properties

thickness t mm	Heat Treatment or Condition	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %	Hardness HBW
5≤t≤10	Cold Drawing (+C)	520~820	≥400	≥7
10<t≤16	Cold Drawing (+C)	500~800	≥360	≥8
16<t≤40	Cold Drawing (+C)	450~750	≥300	≥9
40<t≤63	Cold Drawing (+C)	400~690	≥260	≥11
63<t≤100	Cold Drawing (+C)	360~620	≥235	≥12
16<t≤100	Rolling and Decapping (+SH)	350~620			105~184
16<t≤100	Soft Annealing and Descaling (+A+SH)				≤156
5≤t≤10	Soft Annealing and Cold Drawing (+A+C)				≤242
10<t≤16	Soft Annealing and Cold Drawing (+A+C)				≤238
16<t≤40	Soft Annealing and Cold Drawing (+A+C)				≤222
40<t≤63	Soft Annealing and Cold Drawing (+A+C)				≤204
63<t≤100	Soft Annealing and Cold Drawing (+A+C)				≤184

1 Approximate Comparison Table

International Organization for Standardization	European Standard
ISO	EN	Numerical Grade
C16E	C16E	1.1148

2 Approximate Comparison Table

International Organization for Standardization	European Standard
ISO	EN	Numerical Grade
C16R	C16R	1.1208

3 Approximate Comparison Table

International Organization for Standardization	France	European Standard		United Kingdom
ISO	NF EN/NF	EN	Numerical Grade	BS EN/BS
C16E4	XC18	C16E	1.1148	080M15

4 Approximate Comparison Table

China		Japan	United States	International Organization for Standardization	France	European Standard		Russia	United Kingdom
GB	ISC	JIS	ASTM/AISI	ISO	NF EN/NF	EN	Numerical Grade	GOST	BS EN/BS
15Mn (GB/T 699-2015)	U21152	SWRCH16K	1019 1016 (ASTM A29/A29M:2005)	CC15K (ISO 4954:1993)	XC12	C16E (EN 10083-1:1991+A1:1996) (EN 10084:1998)	1.1148	15Г	080A15 080A17

C16E Corresponding Standards(Same grade name, different standards)

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!