5154 A5154 BD - JIS H 4040-2015

Grade	5154
Other Names
Corresponding Standard	JIS H 4040-2015 Aluminium and Aluminium Alloy Bars and Wires
Classification	Aluminum and Aluminum Alloys
Properties	Corrosion Resistance Weldability

5154 Chemical Element Composition Content (%)

Component	Fe	Si	Be ^*	Mn	Cr	Cu	Ti	Zn	Mg	Other Individual	Other Total	More
Minimum Value	-	-	-	-	0.15	-	-	-	3.1	-	-	Al:余量
Maximum Value	0.4	0.25	0.0003	0.1	0.35	0.1	0.2	0.2	3.9	0.05	0.15	Al:余量

"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.

5154 Mechanical Properties

condition	Mark	Heat Treatment or Condition	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %
Cold drawn bars (BD); d≤10	A5154 O	Annealing (O)	205~285	≥75	A ≥20
Cold drawn bars (BD); d≤10	A5154 H32	Strain-Hardening and Stabilization - 1/4 Hard (H32)	≥250	-	-
Cold drawn bars (BD); d≤10	A5154 H34	Strain-Hardening and Stabilization - 1/2 Hard (H34)	≥270	-	-
Cold drawn bars (BD); d≤10	A5154 H36	Strain-hardening and stabilization - 3/4 hard (H36)	≥290	-	-
Cold drawn bars (BD); d≤10	A5154 H38	Strain-Hardening and Stabilization - 4/4 Hard (H38)	≥310	-	-

① A50mm、A（5.65√S0）- gauge length，S0-Specimen area，s=S0，unit mm sq
② d-diameter、thickness or width across flats, unit mm；s - cross section area, unit mm sq

Approximate Comparison Table Aluminium and Aluminium Alloy

Japan	United States	International Organization for Standardization	Germany		France	European Standard		Russia	Sweden	United Kingdom
JIS	UNS	ISO	DIN EN/DIN	W-Nr.	NF EN/NF	EN	Numerical Grade	GOST	SS	BS EN/BS
5154	A95154	AlMg3	AlMg3	3.3535	5154A	ENAW-AlMg3	ENAW-5754	AMg3	AlMg3	5454

5154 Corresponding Standards(Same grade name, different standards)

1	GB /T 3190-2008
	5154
2	GB /T 3190-2020
	5154
3	JIS H 4040-2015
	5154 A5154 BD
4	ISO 209-2007
	5154 (AlMg3.5)

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!