5454 A5454 BE - JIS H 4040-2015

Grade	5454
Other Names
Corresponding Standard	JIS H 4040-2015 Aluminium and aluminium alloy bars and wires
Classification	Aluminum and Aluminum Alloys
Properties	Strength Corrosion Resistance Weldability

5454 Chemical Element Composition Content (%)

Component	Fe	Si	Mn	Cr	Cu	Ti	Zn	Mg	Other Individual	Other Total	More
Minimum Value	-	-	0.5	0.05	-	-	-	2.4	-	-	Al:余量
Maximum Value	0.4	0.25	1	0.2	0.1	0.2	0.25	3	0.05	0.15	Al:余量

"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.

5454 Mechanical Properties

condition	Mark	Heat Treatment or Condition	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %
Extruded rod (BE); d≤200	A5454 O	Annealing (O)	200~275	≥85	A50mm ≥16
Extruded rod (BE); d≤200	A5454 H111	Strain-Hardening (H111)	200~275	≥85	≥16
Extruded bar (BE); all sizes	A5454 H112	Strain - Only Hardening (H112)	≥215	≥100	≥12

① A50mm、A（5.65√S0）- gauge length，S0-Specimen area，s=S0，unit mm sq
② d-diameter、thickness or width across flats, unit mm；s - cross section area, unit mm sq

5454 Corresponding Standards(Same grade name, different standards)

1	GB /T 3190-2008
	5454
2	DIN 1725-1-1983
	5454 AlMg2.7Mn 3.3537
3	GB /T 3190-2020
	5454
4	JIS H 4040-2015
	5454 A5454 BE
5	GB /T 3191-2019
	5454
6	GB /T 3880.1-2012
	5454

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!