5754 A5754 BE A5754 BD - JIS H 4040-2015

Grade	5754
Other Names
Corresponding Standard	JIS H 4040-2015 Aluminium and Aluminium Alloy Bars and Wires
Classification	Aluminum and Aluminum Alloys

5754 Chemical Element Composition Content (%)

Component	Fe	Si	Mn	Cr	Cu	Ti	Zn	Mg	Other Individual	Other Total	More
Minimum Value	-	-	-	-	-	-	-	2.6	-	-	Al:余量；Mn+Cr:0.1~0.6
Maximum Value	0.4	0.4	0.5	0.3	0.1	0.15	0.2	3.6	0.05	0.15	Al:余量；Mn+Cr:0.1~0.6

"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.

5754 Mechanical Properties

condition	Mark	Heat Treatment or Condition	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %
Extruded bars (BE); d ≤ 150	A5754 O	Annealing (O)	180~250	≥80	A ≥17
Extruded bars (BE); d ≤ 150	A5754 H111	Strain-Hardening (H111)	180~250	≥80	≥17
Extruded bars (BE); d ≤ 150	A5754 H112	Strain - Only Hardening (H112)	≥180	≥80	≥14
Extruded Bar (BE); 150<d≤250		Strain - Only Hardening (H112)	≥180	≥70	≥13
Cold-drawn bars (BD); d≤50	A5754 O	Annealing (O)	≥180	≥80	≥16
Cold Drawn Rod (BD); d≤30	A5754 H14	Strain-Hardening - 1/2 Hard (H14)	≥250	≥180	≥4
Cold Drawn Rod (BD); d≤30	A5754 H34	Strain-Hardening and Stabilization - 1/2 Hard (H34)	≥250	≥180	≥5
Cold drawn bars (BD); d≤10	A5754 H18	Strain - Hardening - 4/4 Hard (H18)	≥280	≥240	≥2
Cold drawn bars (BD); d≤10	A5754 H38	Strain-Hardening and Stabilization - 4/4 Hard (H38)	≥280	≥240	≥3

① A50mm、A（5.65√S0）- gauge length，S0-Specimen area，s=S0，unit mm sq
② d-diameter、thickness or width across flats, unit mm；s - cross section area, unit mm sq

5754 Corresponding Standards(Same grade name, different standards)

1	GB /T 3190-2008
	5754
2	DIN 1725-1-1983
	5754 AlMg3 3.3535
3	GB /T 3190-2020
	5754
4	JIS H 4040-2015
	5754 A5754 BE A5754 BD
5	ISO 209-2007
	5754 (AlMg3)
6	GB /T 3191-2019
	5754
7	GB /T 3880.1-2012
	5754

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!