E295 1.0050 - NF EN 10025-2-2005

Grade	E295
	1.0050
Corresponding Standard	NF EN 10025-2-2005 Hot rolled products of structural steels - Part 2: Technical delivery conditions for non-alloy structural steels
Classification	Carbon Steel

E295 Chemical Element Composition Content (%)

Component	P	S ^①	N ^②
Minimum Value	-	-	-
Maximum Value	0.045	0.045	0.012

◎ The carbon steel series of the French NF EN standard is equivalent to the engineering non-alloy steel of the European standard (EN), and its mechanical properties are the same as the similar non-alloy steel in Germany.
◎ NF old steel number from [NF A35-501 (1983)].
◎ If additional elements are added, they should be mentioned in the inspection report.

① For long products the max. S content can be increased for improved machinability by 0,010 % by agreement if the steel is treated to modify the sulphide morphology and the chemical composition shows min. 0,0020 % Ca.
② The max. value for nitrogen does not apply if the chemical composition shows a minimum total Al content of 0,020 % or if sufficient other N binding elements are present. In this case the N binding elements shall be mentioned in the inspection document.

E295 Mechanical Properties

thickness t mm	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %
Long products and flat products; t≤1	490~660	≥295	≥12(l)
Long and flat products; 1<t≤1.5	490~660	≥295	≥13(l)
Long and flat products; 1.5<t≤2	490~660	≥295	≥14(l)
Long and flat products; 2<t≤2.5	490~660	≥295	≥15(l)
Long and flat products; 2.5<t<3	490~660	≥295	≥16(l)
Long and flat products; 3≤t≤16	470~610	≥295	≥20(l)
Long and flat products; 16<t≤40	470~610	≥285	≥20(l)
Long and flat products; 40<t≤63	470~610	≥275	≥19(l)
Long and flat products; 63<t≤80	470~610	≥265	≥18(l)
Long and flat products; 80<t≤100	470~610	≥255	≥18(l)
Long and flat products; 100<t≤150	450~610	≥245	≥16(l)
Long and flat products; 150<t≤200	440~610	≥235	≥15(l)
Long and flat products; 200<t≤250	440~610	≥225	≥15(l)

◎ l-longitudinal；t-transverse

① For plate, strip and wide flats with widths ≥ 600 mm the direction transverse (t) to the rolling direction applies. For all other products the values apply for the direction parallel (l) to the rolling direction.
② 1Mpa = 1N/mm ² 。
③ These steels are normally not used for channels, angles and sections.

E295 Corresponding Standards(Same grade name, different standards)

1	EN 10025-2-2019
	E295 1.0050
2	VDI 2230-1-2015
	E295 1.0050
3	DIN EN 10025-2-2019
	E295 1.0050
4	Q/BQB 303-2018
	E295
5	NF EN 10025-2-2005
	E295 1.0050

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!