Grade CuZn35Ni2
Germany W-Nr. 2.0540
Old Grade
Corresponding Standard DIN 17672-1-1983
Wrought copper and copper alloys bars;Properties.
Classification Copper and Copper Alloys
Density 8.3 g/cm3
CuZn35Ni2 Chemical Element Composition Content (%)
Component Fe Si Mn Ni Cu Pb Al Sn Other Total More
Minimum Value - - 1.5 2 58 - 0.3 - - Zn:余量
Maximum Value 0.5 0.1 2.5 3 61 0.8 1.5 0.5 0.5
"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.
CuZn35Ni2 Mechanical Properties
diameter/thickness
d
mm
Mark
Heat Treatment or Condition
Tensile Strength
σb
Mpa
Yield Point
σs
Mpa
Elongation or Extension Rate
δ
%
Hardness
HBW
Round, Square, Hexagonal Bars, Flats; Specifications as per agreement 2.0540.08 Extrusion or Hot Forging P (.08) No specification No specification No specification No specification
Round Material; 30≤d<90 2.0540.09 Special F44(.09) ≥440 ≥190 ≥20(A5) ≈120
Square, Hexagonal Material; 27≤d<80 2.0540.09 Special F44(.09) ≥440 ≥190 ≥20(A5) ≈120
Flat Material; 20≤d<50 2.0540.09 Special F44(.09) ≥440 ≥190 ≥20(A5) ≈120
Round Material; 15≤d<50 2.0540.27 Half-Hard + Stress Relief F49 (.27) ≥490 ≥290 ≥18(A5) ≈130
Square, Hexagonal Material; 14≤d<46 2.0540.27 Half-Hard + Stress Relief F49 (.27) ≥490 ≥290 ≥18(A5) ≈130
Flat Material; 12≤d<30 2.0540.27 Half-Hard + Stress Relief F49 (.27) ≥490 ≥290 ≥18(A5) ≈130
Round bars; 6≤d<15 2.0540.31 Hard + Stress Relief F54 (.31) ≥540 ≥390 ≥12(A5) ≈150
Square, Hexagonal Material; 5≤d<14 2.0540.31 Hard + Stress Relief F54 (.31) ≥540 ≥390 ≥12(A5) ≈150
Flat material; 5≤d<12 2.0540.31 Hard + Stress Relief F54 (.31) ≥540 ≥390 ≥12(A5) ≈150
Approximate Comparison Table Copper and Copper Alloy
Germany European Standard
DIN EN/DIN W-Nr. EN Numerical Grade
CuZn35Ni2 2.0540 CuZn35Ni3Mn2AlPb CW710R

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!