CuZn37Pb0.5 2.0332 Ms63Pb - DIN 17671-1-1983

Grade	CuZn37Pb0.5
Germany W-Nr.	2.0332
Old Grade
Corresponding Standard	DIN 17671-1-1983 Wrought copper and copper alloys tube；Properties.
Classification	Copper and Copper Alloys
Density	8.5 g/cm³

CuZn37Pb0.5 Chemical Element Composition Content (%)

Component	Fe	Ni	Cu	Pb	Al	Sn	Other Total	More
Minimum Value	-	-	62	0.1	-	-	-	Zn:余量
Maximum Value	0.2	0.3	64	0.7	0.05	0.1	0.1	Zn:余量

"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.

CuZn37Pb0.5 Mechanical Properties

thickness t mm	Mark	Heat Treatment or Condition	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %	Hardness HBW
Pipe; wall thickness as per agreement	2.0332.08	Extrusion or Hot Forged Tubes P (.08)	No specification	No specification	No specification	No specification
Pipes; t<10	2.0332.10	Soft F29 (.10)	290~370	≤180	≥50	≈70
Pipes; t<10	2.0332.26	Half Hard F37 (.26)	370~440	≥200	≥27	≈110
Pipes; t<5	2.0332.30	Hard F44 (.30)	440~540	≥340	≥12	≈135
Pipes; t＜2	2.0332.32	Tough-Hard F54 (.32)	≥540	≥470	≥6	≈160

Approximate Comparison Table Copper and Copper Alloy

Germany		European Standard
DIN EN/DIN	W-Nr.	EN
CuZn37Pb0.5	2.0332	CuZn37Pb0.5

CuZn37Pb0.5 Corresponding Standards(Same grade name, different standards)

1	DIN 17671-1-1983
	CuZn37Pb0.5 2.0332 (Ms63Pb)
2	DIN 17660-1983
	CuZn37Pb0.5 2.0332 (Ms63Pb)
3	DIN EN 12449-2019
	CuZn37Pb0.5 CW604N
4	EN 12449-2023
	CuZn37Pb0.5 CW604N

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!