Grade CuZn31Si1
European Standard Steel Grade CW708R
Corresponding Standard EN 12163-1998
Classification Copper and Copper Alloys
Density 8.4 g/cm3
CuZn31Si1 Chemical Element Composition Content (%)
Component Fe Si Ni Cu Pb Other Total More
Minimum Value - 0.7 - 66 - - Zn:余量
Maximum Value 0.4 1.3 0.5 70 0.8 0.5
"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.
CuZn31Si1 Mechanical Properties
diameter/width across-flat
d
mm
Mark
Heat Treatment or Condition
Tensile Strength
σb
Mpa
Yield Point
σs
Mpa
Elongation or Extension Rate
δ
%
Hardness
HBW
5<d≤40 CuZn31Si1-R460 R460 ≥460 ≈250* ≥18(A11.3),≥22(A)
5<d≤40 CuZn31Si1-H115 H115 HB: 115~145;HV: 120~150
5<d≤14 CuZn31Si1-R530 R530 ≥530 ≈330* ≥10(A11.3),≥12(A)
5<d≤14 CuZn31Si1-H140 H140 HB: ≥140;HV: ≥145
3<d≤80 CuZn31Si1-M M No specification No specification No specification No specification
① Material condition names and designations:
H - Hardness (Brinell hardness or Vickers hardness), with the suffix number indicating the hardness value.
R - Tensile strength, with the suffix number indicating the minimum tensile strength value.
M - Manufactured without specified mechanical properties. Refer to standard EN 1173-2008.
② A100, A11.3, A - Gauge length.
Approximate Comparison Table Cupper and cupper alloy
Germany European Standard
DIN EN/DIN W-Nr. EN Numerical Grade
CuZn31Si1 2.0490 CuZn31Si1 CW708R

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!