Grade CuZn39Sn1
European Standard Steel Grade CW719R
Corresponding Standard EN 12163-1998
Copper and copper alloys — Rod for general purposes
Classification Copper and Copper Alloys
Density 8.4 g/cm3
CuZn39Sn1 Chemical Element Composition Content (%)
Component Fe Ni Cu Pb Sn Other Total More
Minimum Value - - 59 - 0.5 - Zn:余量
Maximum Value 0.1 0.2 61 0.2 1 0.2
"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.
CuZn39Sn1 Mechanical Properties
diameter/width across-flat
d
mm
Mark
Heat Treatment or Condition
Tensile Strength
σb
Mpa
Yield Point
σs
Mpa
Elongation or Extension Rate
δ
%
Hardness
HBW
5<d≤80 CuZn39Sn1-R340 R340 ≥340 ≈170* ≥25(A11.3),≥30(A)
5<d≤80 CuZn39Sn-H080 H080 HB: 80~120;HV: 85~125
5<d≤50 CuZn39Sn1-R400 R400 ≥400 ≈210* ≥16(A11.3),≥20(A)
5<d≤50 CuZn39Sn1-H105 H105 HB: 105~145;HV: 110~150
5<d≤30 CuZn39Sn1-R460 R460 ≥460 ≈340* ≥10(A11.3),≥12(A)
5<d≤30 CuZn39Sn1-H135 H135 HB: ≥135;HV: ≥140
3<d≤80 CuZn39Sn1-M M No specification No specification No specification No specification
① Material condition names and designations:
H - Hardness (Brinell hardness or Vickers hardness), with the suffix number indicating the hardness value.
R - Tensile strength, with the suffix number indicating the minimum tensile strength value.
M - Manufactured without specified mechanical properties. Refer to standard EN 1173-2008.
② A100, A11.3, A - Gauge length.
Approximate Comparison Table Brass
China United States International Organization for Standardization Germany European Standard Russia
GB ASTM ISO W-Nr. EN Numerical Grade GOST
HSn60-1 60Cu-39Zn-1Sn CuZn39Sn1 CuZn39Sn1 CuZn39Sn1 CW719R ЛО60-1

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!