Grade CuZn40Mn2Fe1
European Standard Steel Grade CW723R
Corresponding Standard EN 12163-1998
Copper and copper alloys — Rod for general purposes
Classification Copper and Copper Alloys
Density 8.3 g/cm3
CuZn40Mn2Fe1 Chemical Element Composition Content (%)
Component Fe Si Mn Ni Cu Pb Al Sn Other Total More
Minimum Value 0.5 - 1 - 56.5 - - - - Zn:余量
Maximum Value 1.5 0.1 2 0.6 58.5 0.5 0.1 0.3 0.4
"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.
CuZn40Mn2Fe1 Mechanical Properties
diameter/width across-flat
d
mm
Mark
Heat Treatment or Condition
Tensile Strength
σb
Mpa
Yield Point
σs
Mpa
Elongation or Extension Rate
δ
%
Hardness
HBW
5<d≤40 CuZn40Mn2Fe1-R460 R460 ≥460 ≈270* ≥15(A11.3),≥20(A)
5<d≤40 CuZn40Mn2Fe1-H110 H110 HB: 110~140;HV: 115~145
5<d≤14 CuZn40Mn2Fe1-R540 R540 ≥540 ≈320* ≥6(A11.3),≥8(A)
5<d≤14 CuZn40Mn2Fe1-H150 H150 HB: ≥150;HV: ≥155
3<d≤80 CuZn40Mn2Fe1-M M No specification No specification No specification No specification
① Material condition names and designations:
H - Hardness (Brinell hardness or Vickers hardness), with the suffix number indicating the hardness value.
R - Tensile strength, with the suffix number indicating the minimum tensile strength value.
M - Manufactured without specified mechanical properties. Refer to standard EN 1173-2008.
② A100, A11.3, A - Gauge length.
Approximate Comparison Table Copper and Copper Alloy
Germany European Standard Russia United Kingdom
DIN EN/DIN W-Nr. EN Numerical Grade GOST BS EN/BS
CuZn40Mn2 2.0572 CuZn40Mn2Fe1 CW723R LMTs58-2 CZ136

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!