Grade CuZr
European Standard Steel Grade CW120C
Corresponding Standard EN 12163-1998
Classification Copper and Copper Alloys
Density 8.9 g/cm3
CuZr Chemical Element Composition Content (%)
Component Zr Other Total More
Minimum Value 0.1 - Cu:余量
Maximum Value 0.2 0.1
"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.
CuZr Mechanical Properties
diameter/width arcoss-flats
d
mm
Mark
Heat Treatment or Condition
Tensile Strength
σb
Mpa
Yield Point
σs
Mpa
Elongation or Extension Rate
δ
%
Hardness
HBW
8<d≤80 CuZr-R180 Solution; R180 ≥180 ≈40* ≥30(A)
8<d≤80 CuZr-H040 Solution; H040 HB: 40~60;
HV: 40~65
4<d≤30 CuZr-R300 Solution heat treatment + cold working + precipitation hardening; R300 ≥300 ≈200* ≥15(A11.3),
≥20(A)
30<d≤50 CuZr-R280 Solution heat treatment + cold working + precipitation hardening; R280 ≥280 ≈180* ≥20(A)
4<d≤50 CuZr-H090 Solution heat treatment + cold working + precipitation hardening; H090 HB: 90~130;
HV: 95~135
4<d≤30 CuZr-R350 Solution heat treatment + cold working + precipitation hardening; R350 ≥350 ≈260* ≥14(A11.3),
≥18(A)
4<d≤30 CuZr-H120 Solution heat treatment + cold working + precipitation hardening; H120 HB: ≥120;
HV: ≥125
4<d≤80 CuZr-M M No specification No specification No specification No specification
① Material condition names and designations:
H - Hardness (Brinell hardness or Vickers hardness), with the suffix number indicating the hardness value.
R - Tensile strength, with the suffix number indicating the minimum tensile strength value.
M - Manufactured without specified mechanical properties. Refer to standard EN 1173-2008.
② A100, A11.3, A - Gauge length.
Approximate Comparison Table Copper and Copper Alloy
Germany European Standard
DIN EN/DIN W-Nr. EN Numerical Grade
CuZr 2.1580 CuZr CW120C

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!