CuZn37Pb1Sn1 CW714R - EN 12166-1998

Grade	CuZn37Pb1Sn1
European Standard Steel Grade	CW714R
Corresponding Standard	EN 12166-1998 Copper and copper alloys — Wire for general purposes
Classification	Copper and Copper Alloys
Density	8.4 g/cm³

CuZn37Pb1Sn1 Chemical Element Composition Content (%)

Component	Fe	Ni	Cu	Pb	Sn	Other Total	More
Minimum Value	-	-	59	0.4	0.5	-	Zn:余量
Maximum Value	0.1	0.3	61	1	1	0.2	Zn:余量

"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.

CuZn37Pb1Sn1 Mechanical Properties

diameter③ d mm	Mark	Heat Treatment or Condition	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %	Hardness HBW
0.1≤d≤20	CuZn37Pb1Sn1-R350	R350	350~450		≥15(A100)， ≥18(A11.3)， ≥20(A)
0.1≤d≤20	CuZn37Pb1Sn1-H100	H100				HV: 100~130
1.5≤d≤8	CuZn37Pb1Sn1-R400	R400	≥400		≥10(A100)， ≥13(A11.3)
1.5≤d≤8	CuZn37Pb1Sn1-H120	H120				HV: ≥120
All specifications	CuZn37Pb1Sn1-M	M	No specification	No specification	No specification	No specification

①Material condition designation: H-Hardness (Brinell or Vickers), the suffix number indicates the hardness value; R-Tensile strength, the suffix number indicates the minimum tensile strength; M-As manufactured, without specified mechanical properties
②A100, A11.3, A-gauge length
③Or equivalent cross-sectional area for polygonal wire.

CuZn37Pb1Sn1 Corresponding Standards(Same grade name, different standards)

1	EN 12166-1998
	CuZn37Pb1Sn1 CW714R
2	DIN EN 12166-1998
	CuZn37Pb1Sn1 CW714R

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!