Grade CuNi12Zn24
European Standard Steel Grade CW403J
Corresponding Standard EN 12163-1998
Classification Copper and Copper Alloys
Density 8.7 g/cm3
CuNi12Zn24 Chemical Element Composition Content (%)
Component Fe Mn Ni Cu Pb Sn Other Total More
Minimum Value - - 11 63 - - - Zn:余量
Maximum Value 0.3 0.5 13 66 0.03 0.03 0.2
"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.
CuNi12Zn24 Mechanical Properties
diameter/width across-flats
d
mm
Mark
Heat Treatment or Condition
Tensile Strength
σb
Mpa
Yield Point
σs
Mpa
Elongation or Extension Rate
δ
%
Hardness
HBW
2<d≤50 CuNi12Zn24-R380 R380 ≥380 ≈270* ≥28(A100),≥33(A11.3),≥38(A)
2<d≤50 CuNi12Zn24-H090 H090 HB: 90~130;
HV: 95~135
2<d≤40 CuNi12Zn24-R450 R450 ≥450 ≈300* ≥8(A100),
≥10(A11.3),
≥12(A)
2<d≤40 CuNi12Zn24-H130 H130 HB: 130~160;
HV: 135~165
2<d≤10 CuNi12Zn24-R540 R540 ≥540 ≈450* ≥2*(A100),
≥3*(A11.3),
≥5(A)
2<d≤10 CuNi12Zn24-H160 H160 HB: 160~190;
HV: 170~200
2<d≤4 CuNi12Zn24-R640 R640 ≥640 ≈550*
2<d≤4 CuNi12Zn24-H190 H190 HB: ≥190;
HV: ≥200
2<d≤50 CuNi12Zn24-M M No specification No specification No specification No specification
① Material condition names and designations:
H - Hardness (Brinell hardness or Vickers hardness), with the suffix number indicating the hardness value.
R - Tensile strength, with the suffix number indicating the minimum tensile strength value.
M - Manufactured without specified mechanical properties. Refer to standard EN 1173-2008.
② A100, A11.3, A - Gauge length.
Approximate Comparison Table Cupper and cupper alloy
Germany European Standard
DIN EN/DIN W-Nr. EN Numerical Grade
CuNi12Zn24 2.0730 CuNi12Zn24 CW403J

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!