Grade CuAl10Fe1
European Standard Steel Grade CW305G
Corresponding Standard EN 12163-1998
Classification Copper and Copper Alloys
Density 7.6 g/cm3
CuAl10Fe1 Chemical Element Composition Content (%)
Component Fe Si Mn Ni Pb Al Zn Sn Other Total More
Minimum Value 0.5 - - - - 9 - - - Cu:余量
Maximum Value 1.5 0.2 0.5 1 0.02 10 0.5 0.1 0.2
"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.
CuAl10Fe1 Mechanical Properties
diameter/width across-flats
d
mm
Mark
Heat Treatment or Condition
Tensile Strength
σb
Mpa
Yield Point
σs
Mpa
Elongation or Extension Rate
δ
%
Hardness
HBW
10<d≤80 CuAl10Fe1-R420 R420 ≥420 ≈210* ≥20(A)
10<d≤80 CuAl10Fe1-H105 H105 HB: 105~145;
HV: 110~150
10<d≤80 CuAl10Fe1-R530 R530 ≥530 ≈420* ≥10(A)
10<d≤80 CuAl10Fe1-H130 H130 HB: 130~170;
HV: 135~175
10<d≤30 CuAl10Fe1-R630 R630 ≥630 ≈480* ≥5(A)
10<d≤30 CuAl10Fe1-H155 H155 HB: ≥155;
HV: ≥165
10<d≤80 CuAl10Fe1-M M No specification No specification No specification No specification
① Material condition names and designations:
H - Hardness (Brinell hardness or Vickers hardness), with the suffix number indicating the hardness value.
R - Tensile strength, with the suffix number indicating the minimum tensile strength value.
M - Manufactured without specified mechanical properties. Refer to standard EN 1173-2008.
② A100, A11.3, A - Gauge length.

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!