Cu-FRHC CW005A - EN 12449-2023

Grade	Cu-FRHC
European Standard Steel Grade	CW005A
Corresponding Standard	EN 12449-2023 Copper and Copper Alloys - Seamless, Round Tubes for General Purposes
Classification	Copper and Copper Alloys
Density	8.9 g/cm³

Cu-FRHC Chemical Element Composition Content (%)

Component	Cu ^①	Ag ^①	O ^②	Other Total ^③
Minimum Value	99.9	-	-	-
Maximum Value	-	0.015	0.04	0.06

"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.

① Including Ag, the maximum content of Ag that can be reached.
② By mutual agreement between the supplier and the demander, the oxygen O content can be allowed to reach up to 0.06%.
③ Other than Ag and O, Higher total impurities content is permitted, subject to agreement between the purchaser and the supplier.

Cu-FRHC Mechanical Properties

Wall thickness t mm	Heat Treatment or Condition	Tensile Strength σ_b Mpa	Specified Plastic Yield Strength Rp_0.2 Mpa	Elongation or Extension Rate δ %	Hardness HBW
t≤20	H035				35~60
t≤20	R200	≥200	≤120	≥35
t≤10	H065				60~90
t≤10	R250	≥250	≥150	≥15
t≤5	H090				85~105
t≤5	R290	≥290	≥250	≥5
t≤3	H100				≥95
t≤3	R360	≥360	≥320	≥3 (given for information only)

Approximate Comparison Table Processing Pure Copper, Silver Copper

China		Japan	United States		International Organization for Standardization		Germany		France	European Standard	Russia
GB	ISC	JIS	ASTM	UNS	ISO	Numerical Grade	DIN EN/DIN	W-Nr.	NF EN/NF	EN	GOST
T2	T11050	C1100 Cu99.90	99.90Cu	C11000	Cu-FRHC	C11000	ECu-57	C11000 2.0090	Cu-FRHC C11000	Cu-FRHC	М1

Cu-FRHC Corresponding Standards(Same grade name, different standards)

1	CEN /TS 13388-2020
	Cu-FRHC CW005A
2	DIN EN 12449-2019
	Cu-FRHC CW005A
3	EN 12449-2023
	Cu-FRHC CW005A
4	EN 13602-2013
	Cu-FRHC CW005A
5	EN 13599-2014
	Cu-FRHC CW005A

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!