CA106 - BS 2875-1969

Grade	CA106
Corresponding Standard	BS 2875-1969 Specification for Copper and copper alloys — Plate
Classification	Copper and Copper Alloys
Density	7.75 g/cm³

CA106 Chemical Element Composition Content (%)

Component	Fe	Si	Mn	Ni	Pb	Al	Zn	Sn	Mg	Other Total ^℗	More
Minimum Value	2	-	-	-	-	6.5	-	-	-	-	Cu: Remainder
Maximum Value	3.5	0.15	0.5	0.5	0.05	8	0.4	0.1	0.05	0.5	Cu: Remainder

"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.

℗ Total impurities, excl. Ni+Mn

CA106 Mechanical Properties

thickness t mm	Heat Treatment or Condition	Tensile Strength σ_b Mpa	Elongation or Extension Rate δ %
10<t≤50	M	≥480	≥31
t>50	M	≥450	≥31

◎ Condition: M-- As manufactured; O-- Annealed (soft); H-- Hard, i.e. produced by cold rolling.

◎ Complies with or falls within ISO recommendation：R428 CuAl8Fe3

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!