Grade CuNi2Be
European Standard Steel Grade CW110C
Corresponding Standard EN 12167-2024
Copper and copper alloys - Profiles and bars for general purposes
Classification Copper and Copper Alloys
Density 8.8 g/cm3
CuNi2Be Chemical Element Composition Content (%)
Component Fe Be Ni Co Other Total More
Minimum Value - 0.2 1.4 - - Cumin:Rem.
Maximum Value 0.2 0.6 2.4 0.3 0.5
"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.
CuNi2Be Mechanical Properties
thickness
t
mm
Mark
Heat Treatment or Condition
Tensile Strength
σb
Mpa
Specified Plastic Yield Strength
Rp0.2
Mpa
Elongation or Extension Rate
δ
%
Hardness
HBW
2≤t≤60 CuNi2Be-R680 R680 ≥680 ≥540 ≥4(A100), ≥6(A11.3), ≥8(A)
2≤t≤100 CuNi2Be-R620 R620 ≥620 ≥460 ≥4(A100), ≥6(A11.3), ≥8(A)
2≤t≤60 CuNi2Be-H210 H210 210~260
2≤t≤100 CuNi2Be-H190 H190 190~250
All specifications CuNi2Be-M M As manufactured As manufactured As manufactured As manufactured
Test pieces shall be in accordance with EN ISO 6892-1:2019, except that 200 mm gauge length is not permitted.
Elongation requirements for rod of thickness or diameter equivalent to the cross sectional area:
ⓐ less than 4 mm (A100 mm);
ⓑ 4 mm up to and including 8 mm (A 11,3);
ⓒ greater than 8 mm (A);
1 Approximate Comparison Table Processing of High Copper Alloys
China Japan United States International Organization for Standardization Germany European Standard Russia
GB ISC JIS ASTM UNS ISO Numerical Grade DIN EN/DIN W-Nr. EN Numerical Grade GOST
TBe0.4-1.8
QBe0.4-1.8
C17510 C1751
C17510
97.8Cu-.4Be-1.8Ni C17510 CuNi2Be0.4 C17510 CuNi2Be C17510
2.0850
CuNi2Be CW110C БрБН0.4-1.8
2 Approximate Comparison Table Copper and Copper Alloy
Germany European Standard
DIN EN/DIN W-Nr. EN Numerical Grade
CuNi2Be 2.0850 CuNi2Be CW110C

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!