CuZn42 CW510L - EN 12167-2024

Grade	CuZn42
European Standard Steel Grade	CW510L
Corresponding Standard	EN 12167-2024 Copper and copper alloys - Profiles and bars for general purposes
Classification	Copper and Copper Alloys
Density	8.4 g/cm³

CuZn42 Chemical Element Composition Content (%)

Component	Fe	Ni	Cu	Pb	Al	Sn	Other Total	More
Minimum Value	-	-	57	-	-	-	-	Zn_min:Rem.
Maximum Value	0.3	0.3	59	0.2	0.05	0.3	0.2	Zn_min:Rem.

"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.

CuZn42 Mechanical Properties

thickness t mm	Mark	Heat Treatment or Condition	Tensile Strength σ_b Mpa	Specified Plastic Yield Strength Rp_0.2 Mpa	Elongation or Extension Rate δ %	Hardness HBW
3≤t≤10	CuZn42-R500	R500	≥500	≥350	≥2(A100), ≥5(A11.3)
3≤t≤20	CuZn42-R430	R430	≥430	≥220	≥6(A100), ≥8(A11.3)
6≤t≤40	CuZn42-R360	R360	≥360	≤320	≥15(A)
3≤t≤10	CuZn42-H135	H135				≥135
3≤t≤20	CuZn42-H110	H110				110~160
6≤t≤40	CuZn42-H090	H090				90~125
All specifications	CuZn42-M	M	As manufactured	As manufactured	As manufactured	As manufactured

Test pieces shall be in accordance with EN ISO 6892-1:2019, except that 200 mm gauge length is not permitted.
Elongation requirements for rod of thickness or diameter equivalent to the cross sectional area:
ⓐ less than 4 mm (A100 mm);
ⓑ 4 mm up to and including 8 mm (A 11,3);
ⓒ greater than 8 mm (A);

CuZn42 Corresponding Standards(Same grade name, different standards)

1	EN 12166-2016
	CuZn42 CW510L
2	DIN EN 12163-2016
	CuZn42 CW510L
3	DIN EN 12166-2016
	CuZn42 CW510L
4	EN 12163-2016
	CuZn42 CW510L
5	EN 12420-2014
	CuZn42 CW510L
6	EN 12167-2024
	CuZn42 CW510L

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!