AlMg5 EN AW-5019 3.3555 EN AW-AlMg5 - DIN EN 1301-2-2008

Grade	AlMg5
Germany W-Nr.	EN AW-5019
Other Names
Old Grade
Corresponding Standard	DIN EN 1301-2-2008 Aluminium and aluminium alloys-drawn wires-Part 2: Mechanical properties
Classification	Aluminum and Aluminum Alloys

AlMg5 Chemical Element Composition Content (%)

Component	Fe	Si	Mn	Cr	Cu	Ti	Zn	Mg	Other Individual	Other Total	More
Minimum Value	-	-	0.1	-	-	-	-	4.5	-	-	Al:Remainder；Mn+Cr:0.1~0.6
Maximum Value	0.5	0.4	0.6	0.2	0.1	0.2	0.2	5.6	0.05	0.15	Al:Remainder；Mn+Cr:0.1~0.6

"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.

AlMg5 Mechanical Properties

condition	Heat Treatment or Condition	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %
Drawn wire; d≤20	Annealing (O)	≤330	150	A100 17
Drawing wire; d≤18	Strain-Hardening - 1/4 Hard (H12)	295~355	255	6
Drawing wire; d≤18	Strain-Hardening - 1/2 Hard (H14)	325~385	315	3
Drawing wire; d≤18	Strain - Hardening - 4/4 Hard (H18)	≥370	360	2
Drawing wire; d≤18	Strain-hardening + stabilization - 1/4 hard (H32)	280~340	205	11
Drawn Wire; d≤15	Strain-hardening + stabilization - 1/2 hard (H34)	310~370	265	8
Drawn wire; d≤10	Strain-hardening + stabilization - 4/4 hard (H38)	≥360	320	4

Approximate Comparison Table Wrought aluminum and aluminum alloy

Germany		European Standard
DIN EN/DIN	W-Nr.	EN	Numerical Grade
AlMg5	3.3555	ENAW-AlMg5	ENAW-5019

AlMg5 Corresponding Standards(Same grade name, different standards)

1	DIN
	AlMg5 3.3555 5056 A
2	DIN EN 1301-2-2008
	AlMg5 EN AW-5019 (3.3555) EN AW-AlMg5
3	DIN 1725-1-1983
	AlMg5 3.3555 5056A
4	ISO 209-2007
	(AlMg5) 5019 5056A
5	JIS H 5202-2010
	Al Mg5

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!