AlCu2.5Mg EN AW-2117 EN AW-AlCu2.5Mg - DIN EN 1301-2-2008

Grade	AlCu2.5Mg
Germany W-Nr.	EN AW-2117
Other Names
Corresponding Standard	DIN EN 1301-2-2008 Aluminium and aluminium alloys-drawn wires-Part 2: Mechanical properties
Classification	Aluminum and Aluminum Alloys

AlCu2.5Mg Chemical Element Composition Content (%)

Component	Fe	Si	Mn	Cr	Cu	Zn	Mg	Other Individual	Other Total	More
Minimum Value	-	-	-	-	2.2	-	0.2	-	-	Al：余量
Maximum Value	0.7	0.8	0.2	0.1	3	0.25	0.5	0.05	0.15	Al：余量

Component	Cr	More
Minimum Value	-
Maximum Value	-

"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.

AlCu2.5Mg Mechanical Properties

condition	Heat Treatment or Condition	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %
Drawing wire; d≤18	Strain-Hardening - 3/8 Hard (H13)	170~240	110	5
Drawn wire; d≤10	Strain - Hardening - 4/4 Hard (H18)	≥260
Drawing wire; d≤18	Solution Heat Treatment + Natural Aging (T4)	≥260	160	20

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!