中文版
Home Material ASTM A 666/A666M-2024
简体 | 繁體
USA UNS S30400
AISI
American Iron and Steel Institute		 304
Corresponding Standard ASTM A 666/A666M-2024
Standard Specification for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar
Classification Austenitic Stainless Steel
Properties Corrosion Resistance
Chemical Element Composition Content (%)
Component C Si Mn P S Cr Ni N
Minimum Value - - - - - 18 8 -
Maximum Value 0.08 0.75 2 0.045 0.03 20 10.5 0.1
Mechanical Properties
Heat Treatment or Condition
Tensile Strength
σb
Mpa 		Yield Point
σs
Mpa 		Elongation or Extension Rate
δ
% 		Hardness
HBW
Annealing ≥515 ≥205 ≥40 ≤201
1 Approximate Comparison Table Austenitic Stainless Steel
China Taiwan, China Japan South Korea United States International Organization for Standardization Germany France European Standard Russia Sweden United Kingdom
GB ISC CNS JIS KS ASTM UNS ISO Numerical Grade DIN EN/DIN W-Nr. NF EN/NF EN Numerical Grade GOST SS BS EN/BS
06Cr19Ni9 S30408 304 SUS 304 STS 304 304 S30400 X5CrNi 18-10 4301-304-00-I X5CrNi 18-10
(X5CrNi 18-9) 		1.4301 Z6CN 18-09 X5CrNi 18-10 1.4301 08Х18Н10 2332
2333 		304S15
2 Approximate Comparison Table Austenitic Heat-Resistant Steel
China Taiwan, China Japan South Korea United States International Organization for Standardization Germany France European Standard Russia Sweden United Kingdom
GB ISC CNS JIS KS ASTM UNS ISO DIN EN/DIN W-Nr. NF EN/NF EN Numerical Grade GOST SS BS EN/BS
06Cr19Ni10
(0Cr18Ni9) 		S30408 304 SUS 304 STS 304 304 S30400 X5CrNi 18-10 X5CrNi 18-10
(X5CrNi 18-9) 		1.4301 Z6CN 18-09 X5CrNi 18-10 1.4301 08Х18Н10 2332
2333 		304S15
3 Approximate Comparison Table Stainless Steels for Cold Heading and Cold Extruding
China Japan United States International Organization for Standardization European Standard
GB ISC JIS ASTM/AISI UNS ISO Numerical Grade EN Numerical Grade
06Cr19Ni10
(0Cr18Ni9) 		S30408 SUS304 304 S30400 X5CrNi18-10 4301-304-00-I X5CrNi18-10 1.4301

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!