Grade 5052
Other Names
Corresponding Standard JIS H 4040-2006
Aluminium and aluminium alloy rods, bars and wires
Classification Aluminum and Aluminum Alloys
Properties Corrosion Resistance Weldability
5052 Chemical Element Composition Content (%)
Component Fe Si Mn Cr Cu Zn Mg Other Individual Other Total More
Minimum Value - - - 0.15 - - 2.2 - - Al:余量
Maximum Value 0.4 0.25 0.1 0.35 0.1 0.1 2.8 0.05 0.15
"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.
5052 Mechanical Properties
diameter
d
mm
Mark
Heat Treatment or Condition
Tensile Strength
σb
Mpa
Yield Point
σs
Mpa
Elongation or Extension Rate
δ
%
5052 H112 Extruded Bar Strain-Hardening (H112) ≥175 ≥70
5052 O Extruded bar annealed (O) 175~245 ≥70 Elongation rate (%) at a length of 50mm
≥20
d≤3 5052 O Cold Drawn Rod/Wire Annealing (O) 170~220
3<d≤100 5052 O Annealing (O) 170~220 ≥65 Elongation rate (%) at a length of 50mm
≥25
3<d≤10 5052 H32 Strain-Hardening and Stabilization - 1/4 Hard (H32) 215~255
3<d≤30 5052 H14 Strain-Hardening - 1/2 Hard (H14) ≥235 ≥180 Elongation at 5.65√So Length%
≥5
3<d≤30 5052 H34 Strain-Hardening and Stabilization - 1/2 Hard (H34) ≥235 ≥180 Elongation at 5.65√So Length%
≥6
d≤10 5052 H18 Strain - Hardening - 4/4 Hard (H18) ≥270 ≥220 Elongation at 5.65√So Length%
≥2
d≤10 5052 H38 Strain-Hardening and Stabilization - 4/4 Hard (H38) ≥270 ≥220 Elongation at 5.65√So Length%
≥2
d: diameter, thickness or width across flats;unit mm
s: cross section area; unit cm²
A、A50mm-gauge length
Approximate Comparison Table Aluminium and Aluminium Alloy
Japan United States International Organization for Standardization Germany France European Standard Sweden United Kingdom
JIS UNS ISO DIN EN/DIN W-Nr. NF EN/NF EN Numerical Grade SS BS EN/BS
5052 A95052 AlMg2 AlMg1.8
AlMg2.5
3.3326 5052 ENAW-AlMg2(B) ENAW-5051A AlMg2.5 5251

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!