25CrNi1MoV - JB /T 7026-2004

Grade	25CrNi1MoV
Corresponding Standard	JB /T 7026-2004 Specification of the Rotors Forgings Used Below 5oMW Turbine Generator
Classification	Alloy Steel

25CrNi1MoV Chemical Element Composition Content (%)

Component	C	Si ^①	Mn	P	S	Cr	Ni	Cu	Mo	V
Minimum Value	0.2	0.17	0.3	-	-	1	1	-	0.25	0.05
Maximum Value	0.28	0.37	0.6	0.025	0.025	1.5	1.5	0.2	0.4	0.15

① For steels produced by the vacuum carbon deoxidation process, the silicon content is permitted to be not greater than 0.10 %.

25CrNi1MoV Mechanical Properties

Forging Class，Location of Test Specimens	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %	Reduction of Area ψ %	Impact Energy Absorption KV2 J
IV，Longitudinal at the Shaft End	≥540	ReL ≥390	≥17	≥40	≥56
IV，Tangential at the Shaft Body	≥540	≥390	≥16	≥35	≥40
V，Longitudinal at the Shaft End	≥590	≥440	≥17	≥40	≥56
V，Tangential at the Shaft Body	≥590	≥440	≥16	≥35	≥40
V，Radial at the Shaft Body	≥540	≥390	≥15	/	/
VI，Longitudinal at the Shaft End	≥640	≥490	≥16	≥35	≥56
VI，Tangential at the Shaft Body	≥640	≥490	≥16	≥35	≥40
VI，Radial at the Shaft Body	≥590	≥440	≥14	≥30	≥40

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!