F468MW Ni 500 N05500 - ASTM F468M-2006(R2012)

Grade	F468MW Ni 500
USA UNS	N05500
Corresponding Standard	ASTM F468M-2006(R2012) Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)
Classification	Nickel and Nickel Alloys

F468MW Ni 500 Chemical Element Composition Content (%)

Component	Fe	C	Si	Mn	S	Ni	Ti	Al	More
Minimum Value	-	-	-	-	-	63	0.35	2.3	Cu:Balance
Maximum Value	2	0.25	0.5	1.5	0.01	70	0.85	3.15	Cu:Balance

F468MW Ni 500 Mechanical Properties

	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %	Hardness HBW
Full-Size, M6~M20	900~1240	≥620		HRC 24~37
Full-Size, M24~M36	900~1240	≥590		24~37
Machined Specimen, M6~M20	≥900	≥620	≥20	24~37
Machined Specimen, M24~M36	≥900	≥590	≥20	24~37

Note1: Where both tension and hardness tests are performed, the tension tests shall take precedence for acceptance purposes.
Note2: The yield and tensile streng1h values for full-size products shall be computed by dividing the yield and maximum tensile load by the stress area for the product diameter and thread pitch as given in table on tensile stress areas

Approximate Comparison Table Corrosion-Resistant Alloy

China		United States		Germany
GB	ISC	Commercial Grade	UNS	W-Nr.
NS 6500 Ni68Cu28Al	H 05500	Monel K500	N 05500	2.4375

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!