F468MFN Ni 59 Grade 1 N06059 - ASTM F468M-2006(R2012)

Grade	F468MFN Ni 59 Grade 1
USA UNS	N06059
Corresponding Standard	ASTM F468M-2006(R2012) Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)
Classification	Nickel and Nickel Alloys

F468MFN Ni 59 Grade 1 Chemical Element Composition Content (%)

Component	Fe	C	Si	Mn	P	S	Cr	Cu	Mo	Co	Al	More
Minimum Value	-	-	-	-	-	-	22	-	15	-	0.1	Ni:Balance
Maximum Value	1.5	0.01	0.1	0.5	0.015	0.01	24	0.5	16.5	0.3	0.4	Ni:Balance

F468MFN Ni 59 Grade 1 Mechanical Properties

	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %	Hardness HBW
Full-Size	825~1140	≥585		HRC 21~45
Machined Specimen	≥825	≥585	≥20	21~45

Note1: Where both tension and hardness tests are performed, the tension tests shall take precedence for acceptance purposes.
Note2: The yield and tensile streng1h values for full-size products shall be computed by dividing the yield and maximum tensile load by the stress area for the product diameter and thread pitch as given in table on tensile stress areas

Approximate Comparison Table corrosion-resistant alloy

China		United States		Germany
GB	ISC	Commercial Grade	UNS	DIN EN/DIN	W-Nr.
NS 3311	H 06059 H 03311	alloy 59	N 06059	Nicrofer 5923 hMo	2.4605

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!