F468MAC Ni 625 N06625 - ASTM F468M-2006(R2012)

Grade	F468MAC Ni 625
USA UNS	N06625
Corresponding Standard	ASTM F468M-2006(R2012) Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)
Classification	Nickel and Nickel Alloys

F468MAC Ni 625 Chemical Element Composition Content (%)

Component	Fe	C	Si	Mn	P	S	Cr	Ni	Mo	Ti	Nb	Co	Al
Minimum Value	-	-	-	-	-	-	20	58	8	-	3.2	-	-
Maximum Value	5	0.1	0.5	0.5	0.015	0.015	23	-	10	0.4	4.2	1	0.4

F468MAC Ni 625 Mechanical Properties

	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %	Hardness HBW
Full-Size	≥825	≥415		85HRB~35HRC
Machined Specimen	≥825	≥415	≥30	85HRB~35HRC

Note1: Where both tension and hardness tests are performed, the tension tests shall take precedence for acceptance purposes.
Note2: The yield and tensile streng1h values for full-size products shall be computed by dividing the yield and maximum tensile load by the stress area for the product diameter and thread pitch as given in table on tensile stress areas

1 Approximate Comparison Table Corrosion-Resistant Alloy

China		Japan	South Korea	United States		Germany		United Kingdom
GB	ISC	JIS	KS	Commercial Grade	UNS	DIN EN/DIN	W-Nr.	BS EN/BS
NS 3306 (NS 336) (0Cr20Ni65Mo10Nb4)	H 06625 (H 03306)	NCF 625	NCF 625	Inconel 625	N 06625	NiCr22Mo9Nb	2.4856	NA 21 NA 43

2 Approximate Comparison Table Wrought Corrosion-Resistant Alloy for Welding

China		United States		International Organization for Standardization
GB	ISC	ASTM	AWS	ISO
HNS 3306 NiCr22Mo9Nb	W 56625	N 06625	ERNiCrMo-3	SNi 6625

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!