F468MY Al 6061-T6 A96061 - ASTM F468M-2006(R2012)

Grade	F468MY Al 6061-T6
USA UNS	A96061
Corresponding Standard	ASTM F468M-2006(R2012) Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)
Classification	Aluminum and Aluminum Alloys

F468MY Al 6061-T6 Chemical Element Composition Content (%)

Component	Fe	Si	Mn	Cr	Cu	Ti	Zn	Mg	Other Individual	Other Total	More
Minimum Value	-	0.4	-	0.04	0.15	-	-	0.8	-	-	Al:Balance
Maximum Value	0.7	0.8	0.15	0.35	0.4	0.15	0.25	1.2	0.05	0.15	Al:Balance

"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.

F468MY Al 6061-T6 Mechanical Properties

	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %	Hardness HBW
Full-Size	260~360	≥215		HRB 40~50
Machined Specimen	≥290	≥240	≥10	40~50

Note1: Where both tension and hardness tests are performed, the tension tests shall take precedence for acceptance purposes.
Note2: The yield and tensile streng1h values for full-size products shall be computed by dividing the yield and maximum tensile load by the stress area for the product diameter and thread pitch as given in table on tensile stress areas

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!