F468MBT Ti 2 R50400 - ASTM F468M-2006(R2012)

Grade	F468MBT Ti 2
USA UNS	R50400
Corresponding Standard	ASTM F468M-2006(R2012) Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)
Classification	Titanium and Titanium Alloys

F468MBT Ti 2 Chemical Element Composition Content (%)

Component	Fe	C	N	H	O	Other Individual	Other Total	More
Minimum Value	-	-	-	-	-	-	-	Ti:Balance
Maximum Value	0.3	0.1	0.05	0.0125	0.25	0.1	0.4	Ti:Balance

"Other individual elements or other totals": The chemical composition includes elements not specified in the table. Analysis should only be conducted if these elements are suspected to be present, or if routine analysis suggests that their content may exceed the prescribed limits.

F468MBT Ti 2 Mechanical Properties

	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %	Hardness HBW
Full-Size	345~580	≥275		HV 168~180
	≥345	≥275	≥20	168~180

Note1: Where both tension and hardness tests are performed, the tension tests shall take precedence for acceptance purposes.
Note2: The yield and tensile streng1h values for full-size products shall be computed by dividing the yield and maximum tensile load by the stress area for the product diameter and thread pitch as given in table on tensile stress areas

Approximate Comparison Table Processing Titanium and Titanium Alloys

China	Japan	United States		European Standard	Russia
GB	JIS	ASTM	UNS	EN	GOST
TA2	Class 3 Ti≥99.32	Grade 2	R50400	T1-P02(Ti≥99.31)	ВТ1-0(Ti99.33)

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!