N07750 Inconel X-750 - SAE J 470c-1976

Commercial Grade
USA UNS	N07750
Other Names
Corresponding Standard	SAE J 470c-1976 WROUGHT NICKEL AND NICKEL-RELATED ALLOYS
Brand/Supplier	America ->
Classification	Nickel and Nickel Alloys
Properties	Corrosion Resistance Low-Temperature Toughness High-Temperature Strength Forgability Weldability
Density	8.28 g/cm³

Chemical Element Composition Content (%)

	Component	Fe	C	Si	Mn	S	Cr	Ni	Cu	Ti	Al	More
Standard	Minimum Value	-	-	-	-	-	-	-	-	-	-	Ca+Ta：0.9
	Maximum Value	-	-	-	-	-	-	-	-	-	-
	Nominal Value	8	0.08	0.5	1	0.01	15.5	73	0.5	2.5	0.7

	Component	Fe	C	Si	Mn	S	Cr	Ni ^①	Cu	Ti	Nb ^②	Co	Al
SMC	Minimum Value	5	-	-	-	-	14	70	-	2.25	0.7	-	0.4
	Maximum Value	9	0.08	0.5	1	0.01	17	-	0.5	2.75	1.2	1	1
	Nominal Value	-	-	-	-	-	-	-	-	-	-	-	-

Standard - The element content in this standard is the average or nominal value, not the maximum value, if you need a more accurate content value, you should contact the manufacturer
Chemical composition of SMC-Special metals corporation
①Include Co
②IncludeTa

Mechanical Properties

diameter d in.	Tensile Strength σ_b ksi	Yield Point σ_s ksi	Elongation or Extension Rate δ %	Reduction of Area ψ %
d＜4	165	105	20	25
d≥4	160	100	15	17

Approximate Comparison Table corrosion-resistant alloy

China		United States		Germany
GB	ISC	Commercial Grade	UNS	DIN EN/DIN	W-Nr.
NS 4102 GH 4145	H 07750	Hastelloy X750	N 07750	NiCr15Fe7TiAl	2.4669

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!