Nickel 200 N02200

Nickel 200 Chemical Element Composition Content (%)

Component	Fe	C	Si	Mn	S	Ni ^*	Cu
Minimum Value	-	-	-	-	-	99	-
Maximum Value	0.4	0.15	0.35	0.35	0.01	-	0.25

*Plus Co

Nickel 200 Mechanical Properties

Form	Heat Treatment or Condition	Tensile Strength σ_b Mpa	Yield Point σ_s Mpa	Elongation or Extension Rate δ %	Hardness HBW
Rod	Hot-Finished	415~585	105~310	35~55	90~150
Rod	Cold-Drawn	450~760	275~690	10~35	140~230
Rod	Cold-Drawn, Annealed or Hot-finished, Annealed	380~520	105~210	40~55	90~120
Plate	Hot-Rolled	380~690	140~550	35~55	100~150
Plate	Hot-Rolled, Annealed	380~550	105~275	40~60	90~140
Thin plate	Hard	620~795	480~725	2~15	HRB ≥90
Thin plate	Annealed	380~520	105~210	40~55	HRB ≤70
Strip	Spring	620~895	480~795	2~15	HRB ≥95
Strip	Annealed	380~520	105~210	40~55	HRB ≤64
Tube	Stress-Relieved	450~760	275~620	15~35	HRB 75~98
Tube	Annealed	380~520	85~210	40~60	HRB ≤70
Condenser, Evaporator Pipe	Annealed	380~520	105~210	40~60	HRB ≤65
Condenser, Evaporator Pipe	Stress-Relieved	450~760	275~620	20~35	HRB 75~98
Cold drawn wire	Annealed	380~580	105~345	30~50
Cold drawn wire	No. 1 Temper	485~655	275~520	20~40
Cold drawn wire	Spring Temper	860~1000	725~930	2~15

Approximate Comparison Table corrosion-resistant alloy

Nickel200 Corresponding Standards(Same grade name, different standards)

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!