Inconel 600 - H2ABC

Inconel 600 Chemical Element Composition Content (%)

Component	Fe	C	Si	Mn	S	Cr	Ni	Cu
Minimum Value	6	-	-	-	-	14	72	-
Maximum Value	10	0.15	0.5	1	0.015	17	-	0.5

Corresponding grade: N06600/ASTM UNS；W.Nr. 2.4816/DIN

Inconel 600 Mechanical Properties

Form	Heat Treatment or Condition	Tensile Strength σ_b Mpa	Specified Plastic Yield Strength Rp_0.2 Mpa	Elongation or Extension Rate δ %	Hardness HBW
Cold-drawn rod and bar	Annealed	550~690	170~345	55~35	HRB: 65~85
Cold-drawn rod and bar	As-drawn	725~1035	550~860	30~10	90HRB~30HRC
Hot-Finished rod and bar	Annealed	550~690	205~345	55~35	HRB: 65~85
Hot-Finished rod and bar	Hot-finished	585~830	240~620	50~30	HRB: 75~95
Hot-rolled plate	Annealed	550~725	205~345	55~35	HRB: 65~85
Hot-rolled plate	As-Rolled	580~760	240~450	50~30	HRB: 80~95
Cold-Rolled sheet	Annealed	550~690	205~310	55~35	HRB: ≤88
Cold-Rolled sheet	Hard	830~1035	620~860	15~2	HRC: ≥24
Cold-Rolled strip	Annealed	550~690	205~310	55~35	HRB: ≤84
Cold-Rolled strip	Spring Temper	1000~1170	830~1100	10~2	HRC: ≥30
Hot-Finished tube and pipe	Hot-Finished Annealed	520~690	170~345	55~35	-
Cold-drawn tube and pipe	Annealed	550~690	170~345	55~35	HRB: ≤88
Cold-drawn wire	Annealed	550~830	240~520	45~20	-
Cold-drawn wire	No.1 Temper	725~930	480~725	35~15	-
Cold-drawn wire	Spring Temper	1170~1520	1035~1045	5~2	-

Inconel600 Corresponding Standards(Same grade name, different standards)

Note: The data is for reference only! If you have any questions, please fill out "I want to correct it"!